4 - Getting Started IG

Principle of Operation

Functional Description

The Intelli-Gauge decodes CAN bus data into human-readable form and displays onto HMI screen. IG is 100% standalone display device and is configurable with our Studio Interface Kit.

General Set-up

To get started, wire Pins 1 and 2 (VBAT) to +12V or +24V and Pin 3 (GND) to Ground. Once power is applied, the default splash screen will be displayed, and will transition to the Graphical User Interface (GUI) application.

Default Splash

The default splash screen is configurable. To replace the default splash screen image, Andromeda's Flasher Tool is available to make this change.

Graphical User Interfaces

The start-up GUI will appear as shown below. These GUIs are configurable through our Studio Interface Kit (SIK)