| Table of Contents |
|---|
Kernel Loading
The EVIC will need the Vantage Vehicle Moxion production kernel binary files installed on the device. The following steps will provide you with the instructions on how to perform this process.
...
5. Select the “Flash” button and wait until it is successfully flashes EVIC. You can monitor the progress bar on the bottom right-corner.
6. Cycle EVIC power
Application Test Verifier
The following instructions will go through the procedure to access, install and test the EVIC board.
Launch the SIK and navigate to the file and open “skin.xml” within the folders @”/ADIM_test_software/skins/ADIM_Milky_verifier/skin.xml”
Plug-in the USB cable into EVIC and power it “On” with +12V. SIK will detect it is connected and ready the flash. Press the “Skin Flash” button to proceed with the installation.
...
3. Unplug the USB cable from EVIC and cycle power “
Off” and “On”. The test application will automatically start and execute the tests for each analog and digital inputs and outputs. The tests are normally done in 2-4 seconds.
4. If the board
Passes, the following message will appear:
...
5. If the board
Fails, the following message will appear:
...
6. Cycle EVIC power
Application Software Loading
The Vantage Moxion software application will need to be loaded onto the EVIC to complete the programming of the unit. The following instructions will go through the procedure to access, install the required software.
...