Kernel Loading
The EVIC will need the EVIC production kernel binary files installed on the device. The following steps will provide you with the instructions on how to perform this process.
Install a boot jumper (2 wires shorted) into the 20-pin wiring harness into pins 19 and 20.
...
2. Plug USB cable from EVIC to Workstation (Host computer)
...
3. Launch the ADIM-Flasher tool and power on the EVIC display with +12V. The board should go into boot mode and initialize. You should see a similar screenshot as shown below.
...
4. Go to the “Settings” page in ADIM-Flasher and select the following binary files in the EVIC Folder: XLDR_NAND.bin → EBOOT.bin → NK.bin → boot_screen.png Press the “Save” button.
5. Select the “Flash” button and wait until it is successfully flashes EVIC. You can monitor the progress bar on the bottom right-corner.
6. Cycle EVIC power
Application Software Loading
The EVIC Combo software application will need to be loaded onto the EVIC to complete the programming of the unit. The following instructions will go through the “Wizzardy Tool” to access, install the required software.
Launch the SIK and and Follow the initial prompts: Select “EVIC 7”” and “Next”
2. Select “Orion” , “Curtis AC1239” for the Interfaces and “250KBPS” for Baud Rate“Next”
...
3. Select “Skin 1” and “Next” then “SKIN IT”
...
4. The SIK design area should look like the below image:
...
5. Plug-in the USB cable into EVIC and power it “On” with +12V. SIK will detect it is connected and ready the flash. Press the “Skin Flash” button to proceed with the installation.
6. Once flash is completed power cycle EVIC device to finish installation of the application software.
Reference Files:
Kernel:
Splash Screen:
...
Application Software:
Use the SIK’s Wizardy tool and select the following skin settings:
...
Select EVIC 7” for Devic type
...
Select Orion + Curtis AC1239 for Interfaces
...
Select 250kpbs for CAN baud rates
...
Select EVIC Combo Skin 2 for skin type
...
to install the EVIC Combo: Orion, Curtis @ 250kbps: